sort by:

Reviews

12" Drop in Replacement for the Miller and Kreisel M&K 4 Ohm Sub Woofers
Price: $65.00
  • Average Rating 5/5 Stars.
  • 1
  • 2
  • 3
  • 4
  • 5
(5 out of 5 with 2 votes)
Product Description:
Mavin EM-TL3006Y-4 Woofer




This is a drop in replacement for any of the standard M&K Woofers used in their Sub Woofer Designs 4 Ohm version.
Mavin's Own 12" High Performance Driver
Rated to 250 Watts RMS with a Minimum SPL of 90 dB
It has a Practical Frequency Range from 25 Hz to 5,250 Hz
Rubber Surround and Heavy Magnet Structure High End Quality at a Mid Level Price.
Simply put, remove the screws from your M&K Sub, unhook a few wires, then just swap out the woofer doing the reverse to install the new driver.
5 minutes and you're done, better still your M&K Sub will sound like new again. At 15 pounds this driver is more efficient than the M&K's meaning that your sub may hit just a little bit harder.

Features
 

  • Stiff Pressed Paper Cone with Rubber Surround
  • 250 Watts RMS Power Rating
  • 4 ohm impedance
  • A Practical Frequency Range from 30 Hz. to 3800 Hz.
  • 2 inch ( 50 mm ) Voice Coil
  • Size 12 3/16" Dia. for a 11 3/16" mounting hole, and a 5 3/8" mounting depth. 8 mounting screws
  • Note that you can also get this speaker in an 16 Ohm Impedance
  • Although generally a drop in replacement, there was a time when 12" woofers tried to go metric, I advise measuring your old driver to see how it stacks up against this Mavin woofer just to ensure fitment.




Thiele Small Specifications

    • Revc = 3.600 ohms
    • Fo = 35 Hz.
    • Sd = 53.093 mM
    • Md = 60.000 g
    • Bl = 7.547T
    • Qms = 2.379
    • Qes = 0.906
    • Qts = 0.656
    • No = 0.549%
    • SPL = 90 dB
    • Vas = 130.532 mM
    • Cms = 326.102u M/N
    • Krm = 5.108 m Ohm
    • Erm = 0.728
    • Mms = 67.034 g
    • Mmd = 60.000 g
    • Kxm = 28.394 mH
  • Exm = 0.577
     




     
 


More Detail

Almost Drop-In for V125
  • Rating 5/5 Stars.
  • 1
  • 2
  • 3
  • 4
  • 5
Nathan (CA) - December 29th 2019
The outer metal part is too large of a diameter for the V125, but I used some foam-rubber weather stripping tape and I was able to install it somewhat, though the foam on the outer part will need some modification for the grill to fit. The driver sounds great.
Excellent driver. Impressive build quality.
  • Rating 5/5 Stars.
  • 1
  • 2
  • 3
  • 4
  • 5
Don M. (Keller, Texas) - January 14th 2011
I tried this as a replacement in my M&K VX-1250 subwoofer. See my review of the 8 ohm version which I also tried (my comments there also apply to this driver.) This 4 ohm driver sounded even better than the 8 ohm version, most likely because the 270 watt M&K amplifier is rated at 4 ohms and this brought out somewhat more more detail.

You won't go wrong with either of these drivers. They both sound great.